Clean existing emblem on the car with rubbing alcohol to prepare for install.

Use hair dryer to heat up existing emblem on the car for 30-45 sec of Heat, 5”-10” away from emblem.

Check up & down direction on back of insert (Rear USA Only) & Peel 3M backing. (Do Not Touch Adhesive)

Align & apply insert to existing emblem. Starting in the center of emblem gets best alignment results.

Press down and hold all 4 corners at the same time to shape insert to emblem curvature. Once it cools, it will form to shape. (If needed apply more heat to both emblem and insert.)

Notes:

Due To The Fragility Of the Insert, It can Break If Attempting To Remove To
Realign. Using a Utility Blade Under The Thicker Portions
of The Insert, Slightly Lifting, Then Using a Sliding Motion to
Help Release is Better vs Pulling Upwards To Help Prevent Breakage.
Although the 3M Adhesive is Very Strong, It May Lose Its Adhesive Bond
Due To Different Ambient Temperatures Over Time.